Product Description
The Grundfos SP 2A-9 is a 0.37kW, 0.5HP multistage submersible bore pump for clean groundwater supply, tank filling, irrigation and pressure boosting. The package combines a 9-stage stainless steel pump with a Grundfos MS402 submersible motor.
Performance
- Flow: 30L/min at approximately 38m head.
- Maximum head: approximately 53m at zero flow.
Use the performance curve to check flow at the total head required by the installation, including pumping water level, delivery height, outlet pressure and pipe resistance.
Construction and water suitability
The pump and impellers are AISI 304 stainless steel. Water-lubricated bearings incorporate sand channels, and the built-in non-return valve limits backflow when the pump stops. The MS402 motor has a sand shield, lip seal and water-lubricated journal bearings.
- Outlet: 32mm (1 1/4") BSP female thread.
- Water: clean, thin, non-aggressive water.
- Maximum sand content: 50g/m3.
Motor and power supply
The 415V three-phase MS402 motor requires external overload protection matched to its nameplate current.
Installation
- Minimum borehole internal diameter: 105mm with the standard connection; allow clearance for the cable, fittings and any cooling sleeve.
- Maximum water temperature: 40°C.
- Minimum water speed past the motor: 0.15m/s.
- Maximum submergence: 150m below the water surface.
Keep the pump inlet submerged. Water must pass around the motor for cooling; fit a flow sleeve where the installation cannot provide the required water speed. Vertical or horizontal installation is permitted, following Grundfos installation instructions.
For automatic tank filling or pressure operation, use suitable level or pressure controls. Use dry-running protection where a falling water level could uncover the pump inlet.